Model 511 is designed to provide uninterrupted production. The bag storage section of the applicator can be reloaded while in operation. It is equipped with an ejector system to remove bags if the duckbill cannot enter the bag valve, allowing production to continue without operator attention.

The 511 valve bag applicator is very versatile. It applies a wide range of bags quickly, and easily adjusts for changes in bag width or length, resulting in minimum changeover time on multi-size operations.

The modular design and internal wiring allow for simple and quick installation. The reliability of the Model 511 is supported by many design features, including a positive, mechanical valve-opening duckbill and bag gripping mechanical claw to apply valve bags to the filling tubes. Only the highest quality electrical, electronic, and pneumatic components are used. The solid state electronic programmable controller is equipped with remote I/0 and servo-drive controller for precise encoder positioning. Troubleshooting of sensors, motors, and other components is performed via touch screen controls.

• 10 ft. long empty storage conveyor
• bag pick up table
• applicator assembly with V-rail and trolley
• programmable controller
• NEMA 12 dusttight electrical enclosures
• totally enclosed motors
• pneumatic motion devices
• touchscreen controls
• SSCC GWC-II packer interface

• variable sized empty bag storage conveyors
• elevating turntable conveyor
• 230V, 3 ph, or 60 Hz power transformers
• other model packer interface

• bag types: multiwall paper pasted valve bags with or without paper sleeve, block-bottom style plastic film valve bags, block bottom style woven polypropylene valve bags
• valve location: upper left folded to face for left hand application, upper right folded to face for right hand application
• bag sizes: 16 - 25" face width, 20 - 36" face length, 3 1/2 - 8" top width (up to 6" valve)
• bag storage section capacity: up to 50 bags per stack, the number of stacks depends upon the length of the bag storage section and bag width
• filling tube spacing: up to 10 ft between end tubes
• filling tube angle: can be assembled for horizontal or five degree tilt filling tubes
• air requirements: 1 cu ft clean dry air at 80 psig per cycle
• electrical requirements: 460 V, 3 ph, 60 Hz, 15 amps
• shipping weight: 4800 lbs.

Contact Us for more information.